Diymore 15 A 400 W Dual Mos Time Delay Relay Dc 5v - 30v สวิทช์ควบคุมตั้งเวลา Timing Relay

15A 400W Digital Dual MOS Time Delay Relay DC 5V-30V Delay Controller Timer Control Switch Timing Relay Trigger Reverse Protect
Dual MOS delay control board dual MOS parallel active output lower internal resistance larger current strong power interface clear and simple powerful one-button emergency stop function (STOP button) with reverse connection protection reverse connection Burn power off memory. Increased sleep mode. After enabling no operation within 5 minutes automatically turn off the display wake up any button! You can set different OP CL LOP parameters these parameters are independent of each other save the setting parameters Automatic power-down save and other functions almost meet all needs!

Specifications:

Working voltage: DC 5V-30V (wide voltage anti-connection protection)
Trigger signal source: high-level trigger DC 3.0V—24V signal ground and system ground to improve the systems anti-interference ability can also short-circuit the ground

Output capacity: DC DC 5V--36V continuous current 15A at normal temperature power 400W!!! Under the condition of auxiliary heat dissipation the maximum current can reach 30A

Product size: 64mm*35mm*19.3mm
Mounting hole: diameter 3mm
Working temperature: -40 ° C ~ 85 ° C

Operating mode

P1 mode: After the signal is triggered the MOS transistor turns on the OP time and then turns off; in the OP time the following operation
P1.1: The signal is triggered again.
P1.2: Signal triggers re-timed again
P1.3: The signal triggers reset again the MOS tube is disconnected and the timing is stopped.
P-2: Give the trigger signal after the MOS transistor is disconnected from the CL time the MOS transistor turns on the OP time. After the timing is completed the MOS transistor is disconnected.
P3.1: Give the trigger signal after the MOS transistor turns on the OP time the MOS tube turns off the CL time then loops the above action the signal is given again in the loop the MOS tube is disconnected the timing is stopped; the number of cycles (LOP) can be set.
P3.2: No need to trigger signal after power-on MOS tube turns on OP time MOS tube disconnects CL time loops the above action; loop number (LOP) can be set
P-4: Signal hold function If there is a trigger signal the timing is cleared the MOS transistor remains on; when the signal disappears the MOS transistor is disconnected after timing the OP; during the timing there is a signal and the timing is cleared.

Relay enable mode

ON : MOS tube is allowed to conduct during OP conduction time
OFF : MOS tube is disabled always off
Short press the STOP button on the main interface to switch between ON and OFF. The current state will flash then return to the main interface. This function is the emergency stop function. One button is used to open and close the MOS tube.
Sleep mode (long press the stop button to view the current mode)
C-P sleep mode: within five minutes without any operation the digital tube automat